BMWCCT台灣車主聯誼會 - 查看單個文章

Anakus · 2004-10-21, 05:17 AM

[這篇文章最後由Anakus在 2004/10/21 06:19am 第 2 次編輯]

From: BMW@comet.net (Phil Marx)
Subject: re: 87 535iS AC
>Subject: 87 535iS AC
>
>I just bought a 1987 535IS and love it. I can';t get the AC to really get
>cool. The car just had the cooling system replaced (radiater, hoses, etc)
>also the ac drier was replaced. Part of the problem comes from air that
>constanly blows in from underneath the dash on the driver';s side. It blows
>in from the engine compartment, so needless to say it is hot air which makes
>the problem worse.
>Thanks in advance for any advice.
>
>John Thomson
Usually this is caused by a missing blank-plug in the firewall near the steering column entry point. This hole is covered by a plastic plug about 35-40mm in diameter. The plug just snaps in, no insulation, nothing. It will also quiet those clicking injectors you hear inside the cabin. Most use an oval plug 35x40mm part number 51.71.1.872.829 (which can';t cost $1 but is a bear to find on the film). If you have the 35mm round, it is part #51.71.1.816.805. Get up under your dash with a flashlight and poke around with your fingers behind the carpet to find the hole. Not too bad in the winter but will burn your feet in the summer. You might also find the piece dropped behind the carpet, if you feel like tearing it up to look. The fit is not very tight on the plugs. (The second time I used silicone glue!)
簡要翻譯：
車主．．
1987 535IS，換修了不少AC的零配件，卻仍有一股熱氣
由引擎室隔版防火牆竄入駕駛座底部，
當然冷氣空調情況之差，是無庸置疑。
感謝你給予的任何建議。
BMW技師．．
通常這種狀況，起因於轉向柱於防火牆入口的塑膠塞環脫落，
塑膠塞環直徑約35~40mm，塑膠塞環只是扣住。
通常使用橢圓形環 35x40mm 料號 part number 51.71.1.872.829
如果是用正圓形環 35mm round 料號 part number 51.71.1.816.805
用手電筒及手....至地毯下摸索...以找到孔位，
這孔洞雖然冬天不錯，可溫腳。但夏天就會熱給你死。
你可能也可找到之前的塑膠塞環碎片於地毯下。
將新塑膠塞環裝上，並不會很緊
(因此我再次安裝時會用silicone(矽麗控)將其膠合。
----------希望能有些許幫助..........圖我還是會找! :em25: :em18:

2004-10-21, 05:17 AM	#21
Anakus 正式會員註冊日期: 2004-05-31 住址: 北市信義文章: 3,131 精華: 4 贊助: 2005	冷氣出風口有的是熱風有的是冷氣 [這篇文章最後由Anakus在 2004/10/21 06:19am 第 2 次編輯] From: BMW@comet.net (Phil Marx) Subject: re: 87 535iS AC >Subject: 87 535iS AC > >I just bought a 1987 535IS and love it. I can';t get the AC to really get >cool. The car just had the cooling system replaced (radiater, hoses, etc) >also the ac drier was replaced. Part of the problem comes from air that >constanly blows in from underneath the dash on the driver';s side. It blows >in from the engine compartment, so needless to say it is hot air which makes >the problem worse. >Thanks in advance for any advice. > >John Thomson Usually this is caused by a missing blank-plug in the firewall near the steering column entry point. This hole is covered by a plastic plug about 35-40mm in diameter. The plug just snaps in, no insulation, nothing. It will also quiet those clicking injectors you hear inside the cabin. Most use an oval plug 35x40mm part number 51.71.1.872.829 (which can';t cost $1 but is a bear to find on the film). If you have the 35mm round, it is part #51.71.1.816.805. Get up under your dash with a flashlight and poke around with your fingers behind the carpet to find the hole. Not too bad in the winter but will burn your feet in the summer. You might also find the piece dropped behind the carpet, if you feel like tearing it up to look. The fit is not very tight on the plugs. (The second time I used silicone glue!) 簡要翻譯：車主．． 1987 535IS，換修了不少AC的零配件，卻仍有一股熱氣由引擎室隔版防火牆竄入駕駛座底部，當然冷氣空調情況之差，是無庸置疑。感謝你給予的任何建議。 BMW技師．．通常這種狀況，起因於轉向柱於防火牆入口的塑膠塞環脫落，塑膠塞環直徑約35~40mm，塑膠塞環只是扣住。通常使用橢圓形環 35x40mm 料號 part number 51.71.1.872.829 如果是用正圓形環 35mm round 料號 part number 51.71.1.816.805 用手電筒及手....至地毯下摸索...以找到孔位，這孔洞雖然冬天不錯，可溫腳。但夏天就會熱給你死。你可能也可找到之前的塑膠塞環碎片於地毯下。將新塑膠塞環裝上，並不會很緊 (因此我再次安裝時會用silicone(矽麗控)將其膠合。 ----------希望能有些許幫助..........圖我還是會找! :em25: :em18: